| Name | Description | Brochure | |
| LLS-AF-20310 digital fuel level sensors with analog output 0 – 20 Volt; Length of probe 700 mm - 3000 mm |
Applications:
Digital fuel level sensors model LLS-AF-20310 are dedicated to fast and simple connection to the GPS/GSM tracker or remote terminal unit (RTU) with analog voltage input. Note! PKC 40131 cable 7 meters length ordered and purchased separately. |
||
| LLS-20160 digital fuel level sensors with digital output RS232/RS485; Length of probe 700 mm - 3000 mm |
Applications:
Digital fuel level sensors model LLS-20160 are dedicated to connection the GPS/GSM tracker or remote terminal unit (RTU) with serial input RS 232/RS485. |
||
| LLS-20230 digital fuel level sensors with digital output RS232/RS485 and intrinsically safe design; in set with bis 20240 barrier power supply, legth of probe 1500-3000 mm |
Applications:
Digital fuel level sensors model LLS-20230 are dedicated to connection the GPS/GSM tracker or remote terminal unit (RTU) with serial input RS 232/RS485. |
||
| UNU – reusable tool (in set with power supply and cables) |
UNU secured connection between LLS sensors and DALCON device to PC (laptop) during calibration and tuning. |
||
| DALCON device Applied if the vehicle is equipped with 2 engine feeding fuel tanks |
Intended to collect and proceed fuel level data from 2 x LLS20160 sensors and further connection to single RS232 (OMNICOMM communication protocol) or to 0-5 V input of GPS/GSM tracker or RTU. |
||
| BIS -20240 Intrinsically safe barrier (special power supply unit) for LLS-20230 fuel level sensor intended to use in potential hazardous area |
Applied to provide the limitation rate of the electrical current consumed by LLS-20230 during operation. This feature doesn’t allow the “Spark” energy. |
||
| PKC 40130 |
Dedicated to LLS 20160 sensors connection. FCI connector on one side, 6 flying leads on the other side. |
||
| PKC 40131 |
Dedicated to LLS –AF-20310 sensors connection. FCI connector on one side, 4 flying leads on the other side. |
||
| KTZ-10 |
Dedicated to LLS 20160 sensors connection. FCI connector on one side, FCE connector on another side. |
||
| Flat metall cap 6250 and rubber seal |
Cover and seal the fitting area of LLS sensor after it was removed from the place of installation. |
||
| BAQ 60/80 fuel tank inlet cap (plug) sensor RFID technology based |
Monitor OPEN/CLOSE status of the fuel tank inlet. Can be connected to the vehicle’s alarm system or trigger the digital input of GPS/GSM tracker. Standard inlet OD 80 mm, SCANIA OD 60 mm. |
||
| RFA Resistive float adapter |
ON DEVELOPMENT |













